![\"\"](\"http:\/\/threeformfashion.com\/wp-content\/uploads\/2014\/07\/14460707690_1d683f706e_o.jpg\" "\\"14460707690_1d683f706e_o\\"")
<\/a><\/p>\nAfter some initial testing we were able to get the accelerometer data flowing into Ableton and do some basic triggering and pitch bending<\/p>\n
To create the harness we used photogrammetry to capture the body shape. Reference points are drawn to enhance 3D reconstruction, and an outline previews the placement. The plan is to build a 3D printed frame that conforms to the body and makes a stable mount for the phone.<\/p>\n <\/p>\n In the modeling phase, I initially just traced out reference points, but also did extensive form studies of intricate designs. Ultimately we ended up printing only the center section for practical reasons.<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/a>The printed harness was pretty stable and the accelerometer output was fairly noise free. One major challenge was transforming the raw data in a way that was intuitive for the performer. By recording\u00a0 full range of sample motions we were able to set useful ranges and connect them to parameters of the triggered sounds.<\/p>\n